Question DetailsNormal
$ 18.00
Ergonomic Evaluation of Surfacing and Finishing Tasks during Eyeglass Manufacturing-Minnesota
Question posted by
request

Select one of the three NIOSH Health Hazard Evaluation Reports listed below, and perform a critical analysis of the report.

Option 1. Health Hazard Evaluation Report, HETA 2010-0114-3168. (2012). Ergonomic Evaluation of Surfacing and Finishing Tasks during Eyeglass Manufacturing – Minnesota.http://www.cdc.gov/niosh/hhe/reports/pdfs/2010-0114-3168.pdf

Option 2. Health Hazard Evaluation Report, HETA 2010-0008-3148. (2011). Ergonomic and Safety Climate Evaluation at a Brewery – Colorado.

http://www.cdc.gov/niosh/hhe/reports/pdfs/2010-0008-3148.pdf

Option 3. Health hazard evaluation report, HETA 2007-0098-3061. (2008). Ergonomic Evaluation of Frank Hangers at a Turkey Processing Plant - California.

http://www.cdc.gov/niosh/hhe/reports/pdfs/2007-0098-3061.pdf

Your case study review must include the following headings per APA guidelines:

1.       Introduction –Provide a description of the selected case. Describe the issues of the case, and state the purpose for the paper.

2.       Methods – State the evaluation criteria used in the NIOSH HHE Report.

3.       Results – Present the findings from the Health hazard evaluation.

4.       Recommendations – Describe the recommendations for improvements.

5.       Discussion – Review relevant literature on the subject. Does research support the recommendations of the case?

In addition, are there any other issues of concern?

6.       Conclusion – Present your comments on the case. What did you learn in this review? What more would you like

to have seen discussed in the report? In general, your own opinions should only be included in this section.

Instructions:

Your answer to this assignment must be four to six pages, double spaced, and 12 point font (separate title page and reference page are not included in the page length). The assignment requires that you use your textbook and at least two other references and readings which pertain to the topic in question. 

Available Solution
$ 18.00
Ergonomic Evaluation of Surfacing and Finishing Tasks during Eyeglass Manufacturing-Minnesota
  • This solution has not purchased yet.
  • Submitted On 24 Aug, 2017 12:07:18
Solution posted by
solution
Ergonomic Evaluation of Surfacing and Finishing Tasks during Eyeglass Manufacturing-MinnesotaErgonomic Evaluation of Surfacing and Finishing Tasks during Eyeglass Manufacturing-MinnesotaErgonomic Evaluation of Surfacing and Finishing Tasks during Eyeglass Manufacturing-Minnesota...
Buy now to view full solution.
closebutton

$ 629.35